No keyboard, mouse or picture

[BigMudTrux]

Yea i could use some idea which pin outs i. Suppose to use , please

[BigMudTrux]

Best i can show, red light on the “VGA” pin in right lower corner

[BigMudTrux]

Best i can show, red light on the “VGA” pin in right lower corner

[PeterOz]

It is part of header 13.
Look at page 13 & page 18

https://download.gigabyte.com/FileList/Manual/mb_manual_x470-aorus-ultra-gaming_1001_e_200707.pdf?v=b696b970f68a4637be1a8f35d651e316

[BigMudTrux]

So i get 2 short beeps and 4 short beeps

Memory and clock malfunction?

[phillpower2]

So i get 2 short beeps and 4 short beeps

Memory and clock malfunction?

Is this with just the one stick of RAM in slot A2.

[BigMudTrux]

Is this with just the one stick of RAM in slot A2.

As of right now, yes

[phillpower2]

Try the other RAM in just slot A2 and make a note of the results.

Next, remove all RAM from the board and power up to see if the beep pattern changes.

[BigMudTrux]

Tried all ram in A2, then tried all ram in A1.. All make 2 beeps then 4 beeps..

No beeps at all with no ram installed

I also tried A1 and 2 slots multi ram stick in various configurations and the B3 and B4 in various dtick configurations. All with the same 2 beeps and thrn 4 beeps..

[PeterOz]

No beeps at all with no ram installed

Not good

All make 2 beeps then 4 beeps..

Hate to be a pain but the beeps will have a sequence. E.G 2 Short beeps and 4 long beeps or 2 long 4 short etc.
It makes a difference, so what is the sequence.

[BigMudTrux]

Not good

Hate to be a pain but the beeps will have a sequence. E.G 2 Short beeps and 4 long beeps or 2 long 4 short etc.
It makes a difference, so what is the sequence.

They are short beeps

[BigMudTrux]

2 short and 4 short beeps

[PeterOz]

@phillpower2 Do you think the cmos battery could be part of this?

[phillpower2]

@phillpower2 Do you think the cmos battery could be part of this?

Suggested a CMOS battery check last week and the OP said that it had been changed Peter.

Would still suggest a now CMOS battery and if still no change in any of the behaviour you need to swap a known good PSU for testing purposes, if still no change, based on the no beeps with no RAM in the board I would suspect that the board is bad.

[BigMudTrux]

There is currently no cmos battery in the board, it was removed a while ago because i would have to replace ot weekly and reinstall windows weekly. It worked great with it removed until now..