Black screen Crashes

[BoxMan]

Back to the power supply, EVGA make a bunch, spread out across the complete quality spectrum to cover all price points, see here; PSU Tier List rev. 17.0g - Cultists Network
They have models in the Tier A - High End range, and in each range, right down to the Tier F - Replace Immediately.

While 600w isn’t too bad, the model/version of the PSU comes into play if it isn’t supplying a consistent, clean, sine wave across all the voltage rails.
So when you can, pull off that metal cover you marked in the photo and find us the make/model of the EVGA unit. (y)

Alright thank you for all of the help so far???

[BoxMan]

Right click on start & choose powershell/terminal with admin & type/copy & paste these cmds one at a time then click Enter:
If you must you can use CMD as admin

What do I do after doing the code also for the code it was writing it individually then pressing enter before the next code?

[PeterOz]

also for the code it was writing it individually then pressing enter before the next code?

Right click on start & choose powershell/terminal with admin & type/copy & paste [COLOR=rgb(65, 168, 95)]these cmds one at a time then click Enter:[/COLOR]

[PeterOz]

What do I do after doing the code also for the code

Any errors?

[BoxMan]

Right click on start & choose powershell/terminal with admin & type/copy & paste [COLOR=rgb(65, 168, 95)]these cmds one at a time then click Enter:
[/COLOR]

[COLOR=rgb(65, 168, 95)]
So click enter one at a time just making sure I did it correctly

Any errors?

In event viewer?[/color]

[PeterOz]

Copy and paste the first line press enter
Let it run.
When finished copy and paste the second line and let it run.
Repeat till all cmds are done.

[PeterOz]

No not event viewer
From the commands

[BoxMan]

Copy and paste the first line press enter
Let it run.
When finished copy and paste the second line and let it run.
Repeat till all cmds are done.

I was about to do it and the issue happened again I was in the Lock Screen after turning my pc on for 1 minute

[PeterOz]

Try post #27

[Bruce]

@BoxMan - what’s the latest?

[BoxMan]

Try post #27

I didn’t even get to do post 30 tho

[BoxMan]

@BoxMan - what’s the latest?

I had to go away for a vacation but I’ll update you once I get back tho

[PeterOz]

It does not matter if you do post # 27 or Post #30 first.
I suggest you do both

[BoxMan]

go here and download the win 11 driver
https://www.gigabyte.com/Graphics-Ca...port-dl-driver
Go here and download DDU.

https://www.guru3d.com/download/display-driver-uninstaller-download/

and read this at least on the page.
Recommended usage x 2 headings on the same page.

Edited by PeterOz

Do I uninstall the previous drivers?

[PeterOz]

Re read post # 27
You download DDU. READ HOW TO USE IT on the download page.
Then reinstall the driver you downloaded