LCD display shattered, connect to PC or TV?

Hi, so the procedure in method 1) below which instruct to type this command adb shell settings put global usb_debugging_enabled 1
is misleading?





Method 1:

Connect your phone to your computer using a USB cable.
Open a command prompt window on your computer.
Type the following command:

adb devices

This will list all of the connected devices. Your phone should be listed in the output. 4. Type the following command to enable USB debugging:

adb shell settings put global usb_debugging_enabled 1

Your phone will reboot and USB debugging will be enabled.

Method 2: Booting into Recovery Mode

Press and hold the power button and the volume down button at the same time until your phone enters the bootloader menu.
Use the volume buttons to navigate to the “Recovery mode” option and press the power button to select it.
Your phone will boot into recovery mode.
Use the volume buttons to navigate to the “Advanced” or “Options” menu.
Use the power button to select the “ADB debugging” option.
Your phone will reboot and USB debugging will be enabled.

I hope this article was helpful. Please let me know if you have any other questions.

When I type "adb devices" the phone is not detected. I read that drivers must be installed but not sure if that's the issue, I sent an email to the manufacturer for these drivers but who knows if that will go anywhere. What is it meant by adb server?

Hi, no I haven't installed any software on the PC, following this explanation there was no mention of installing software, and use the prompt. But sure I have no problem to install sotware on the PC if that's what's needed.

Connect your phone to your computer using a USB cable.
Open a command prompt window on your computer.
Type the following command:
adb devices
This will list all of the connected devices. Your phone should be listed in the output. 4. Type the following command to enable USB debugging:
adb shell settings put global usb_debugging_enabled 1

10