Hello!
Yesterday I finished my new PC build. I booted it and got into BIOS, everything looked just fine. All components was detected and CPU temp was stable at around 25 C.
Only change I did was to activate TPM 2.0 since that was required to install Windows 11.
So I have a copy of Windows 11 on a USB flashdrive, I plugged it in but I got a error code (0X8007025d). I tried different USB ports, both on the case and on the MOBO.
I also tried a different flash drive. During this process I turned off and on the PC o couple of times to restart the Windows installer.
But eventually I just lost signal to the monitor and got the red CPU LED on the MOBO.
Anyone have any idea? Everything was working just fine, so I doubt anything is not seated or installed correct.
CPU is Ryzen 9 5900X,
Motherboard: MSI MAG X570S Tomahawk
RTX 3090 and 2 sticks of 16gb 3600MHz Ram, if that matters.
Anyone got any advice?
Thanks.
Yesterday I finished my new PC build. I booted it and got into BIOS, everything looked just fine. All components was detected and CPU temp was stable at around 25 C.
Only change I did was to activate TPM 2.0 since that was required to install Windows 11.
So I have a copy of Windows 11 on a USB flashdrive, I plugged it in but I got a error code (0X8007025d). I tried different USB ports, both on the case and on the MOBO.
I also tried a different flash drive. During this process I turned off and on the PC o couple of times to restart the Windows installer.
But eventually I just lost signal to the monitor and got the red CPU LED on the MOBO.
Anyone have any idea? Everything was working just fine, so I doubt anything is not seated or installed correct.
CPU is Ryzen 9 5900X,
Motherboard: MSI MAG X570S Tomahawk
RTX 3090 and 2 sticks of 16gb 3600MHz Ram, if that matters.
Anyone got any advice?
Thanks.