• Hi there and welcome to PC Help Forum (PCHF), a more effective way to get the Tech Support you need!
    We have Experts in all areas of Tech, including Malware Removal, Crash Fixing and BSOD's , Microsoft Windows, Computer DIY and PC Hardware, Networking, Gaming, Tablets and iPads, General and Specific Software Support and so much more.

    Why not Click Here To Sign Up and start enjoying great FREE Tech Support.

    This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

no display.

Status
Not open for further replies.

ilham90

PCHF Member
Apr 6, 2022
14
0
26
Hello everyone!
1)I bought a new case and moved my all my hardware into it ,but when i powered on my pc and it read "no signal" on my monitor . I checked my GPU,Monitor,HDMI and they all work fine , but when i removed one ram stick (4 gb) i managed to get my pc running . Then , i placed the other stick( 8 gb ) in the slot that the 4gb stick used to be in and i got the no signal error again . So, i think it might be that the slot is faulty or sth , but it used to work fine before getting the new case.

2)This case(Coolermaster mb320l) has some RGB lighting , but i don't know where to plug the pins.it has these gigabyte and asus,msi,asrock wires and my mb(h510 gigabyte) doesn't seem to have rgb connectors,but it does have a Led_c connector.

Thank you for your attention


Regards

my specs are as follows:
h510 mb
12gb ram
i5 11400F
1050 ti
 
ignoring the RGB issue for now, you just picked up all the components from the old case and put them into the new case?

so the only change apart from the physical case is what; the motherboard mount points?
you used the same internal cables from the PSU to the various parts, and from the motherboard to the appropriate parts?
the back I/O plate was the same size?
anything the new case has that the old didn't - like a USB3 port - that is now in use and wasn't before?
 
  • Like
Reactions: veeg
Yes nothing new other than the case.I don't use front panel stuff,So it's not USB3 that is causing the problem.I did some more experimenting after creating this thread and my PC is running OK with 8 gbs of memory in the first slot.i think it is very likely that my second slot is broken,because i might have experted a little too much force on my motherboard while mounting it,but i don't think that is the cause of my problem.I didn't really apply much pressure and these things shouldn't take damage that easily.the only difference is the front fans' cable and front panel power,reset sw cables which has nth to with memory.

as for the rgb issue,I think that's kinda solved.My mb basically doesn't support aRGB as it only has a 4 pin male connector for standardRGB.I need a rgb converter to solve my problem which amazon doesn't ship to my country.
 
so all is now good as long as you use the first RAM slot?
sounds like you have two different memory sticks, a 8GB and a 4GB, are they the same make/model?

mind you, they both worked in the old case, and now, not in the new case - and the only difference is a suspected damaged mobo.
 
Status
Not open for further replies.