Hi everyone this is my first post and I’m not very technologically literate so bare with me, I recently upgraded from 16gb ram (no clue what the mhz was) but it was set at 2133 in task manager I was unaware you could change it, after installing the new ram I launched into windows regularly and it worked fine, task manager showed 2133 mhz and cpu-z showed a range of 1000-1100 which I think is odd, I then went into bios and enabled xmp and set the dram frequency to 3200mhz, then my computer would do nothing for about a min, then my monitor turns off and I boot up but don’t make it to windows and I’m forced to press f1 and go into bios, disabling xmp lets me boot into windows fine and then of course enabling it again sticks me with the same issue, so far I’ve reset my CMOS and I’ve held down the power button for 30 seconds and let it sit for a few minutes, no help.
If anyone knows a solution I would really appreciate it, here are my mother board and ram
If anyone knows a solution I would really appreciate it, here are my mother board and ram
| ASUSTeK COMPUTER INC. PRIME H810M-E R2.0 |
